Wikia

Geology Wiki

Magma

Talk0
459pages on
this wiki

Magma is molten rock located beneath the surface of the Earth (or any other terrestrial planet), and which often collects in a magma chamber. Magma may contain suspended crystals and gas bubbles. By definition, all igneous rock is formed from magma.


Magma is a complex high-temperature fluid substance. Temperatures of most magmas are in the range 700°C to 1300°C, but very rare carbonate melts may be as cool as 600°C, and komatiite melts may have been as hot at 1600°C. Most are silicate solutions.

It is capable of intrusion into adjacent rocks or of extrusion onto the surface as lava or ejected explosively as tephra to form pyroclasic rock.

Environments of magma formation and compositions are commonly correlated. Environments include subduction zones, continental rifts, mid-oceanic ridges, and hotspots, some of which are interpreted as mantle plumes. Environments are discussed in the entry on igneous rock. Magma compositions may evolve after formation by fractional crystallization, contamination, and magma mixing.

Melting of solid rock Edit

Melting of solid rock to form magma is controlled by three physical parameters; its temperature, pressure and composition. Mechanisms are discussed in the entry for igneous rock.

TemperatureEdit

At any given pressure and for any given composition of rock, a rise in temperature past the solidus will cause melting. Within the solid earth, the temperature of a rock is controlled by the geothermal gradient and the radioactive decay within the rock. The geothermal gradient averages about 25°C/km with a wide range from a low of 5-10°C/km within oceanic trenches and subduction zones to 30-80°C/km under mid-ocean ridges and volcanic arc environments.

PressureEdit

Melting can also occur when a rock rises through the solid earth by a process known as decompression melting. Unlike pressure melting of ice, most solids sustain higher melting points when pressure is applied, due to the spacial efficiency of their crystal structure as solids. Therefore, if the pressure is decreased, but the temperature remains the same, the melting point of the mineral is lowered, and the minerals within the rock become plastic or liquid. It is in this way that rocks moving upward through the lithosphere can melt. Also keep in mind that each mineral has a different melting point and a different crystal structure. It is because of this that partial melt can occur.

CompositionEdit

It is usually very difficult to change the bulk composition of a large mass of rock, so composition is the basic control on whether a rock will melt at any given temperature and pressure. The composition of a rock may also be considered to include volatile phases such as water and carbon dioxide.

The presence of volatile phases in a rock under pressure can stabilize a melt fraction. The presence of even 1% water may reduce the temperature of melting by as much as 100°C. Conversely, the loss of water and volatiles from a magma may cause it to essentially freeze or solidify.

Partial meltingEdit

When rocks melt they do so incrementally and gradually; most rocks are made of several minerals, all of which have different melting points, and the phase diagrams that control melting commonly are complex. As a rock melts, its volume changes. When enough rock is melted, the small globules of melt (generally occurring in between mineral grains) link up and soften the rock. Under pressure within the earth, as little as a fraction of a percent partial melting may be sufficient to cause melt to be squeezed from its source.

Melts can stay in place long enough to melt to 20% or even 35%, but rocks are rarely melted in excess of 50%, because eventually the melted rock mass becomes a crystal and melt mush that can then ascend en masse as a diapir, which may then cause further decompression melting.

Primary meltsEdit

When a rock melts, the liquid is known as a primary melt. Primary melts have not undergone any differentiation and represent the starting composition of a magma. In nature it is rare to find primary melts. The leucosomes of migmatites are examples of primary melts. Primary melts derived from the mantle are especially important, and are known as primitive melts or primitive magmas. By finding the primitive magma composition of a magma series it is possible to model the composition of the mantle from which a melt was formed, which is important in understanding evolution of the Earth's mantle.

Parental meltsEdit

Where it is impossible to find the primitive or primary magma composition, it is often useful to attempt to identify a parental melt. A parental melt is a magma composition from which the observed range of magma chemistries has been derived by the processes of igneous differentiation. It need not be a primitive melt.

For instance, a series of basalt flows are assumed to be related to one another. A composition from which they could reasonably be produced by fractional crystallization is termed a parental melt. Fractional crystallization models would be produced to test the hypothesis that they share a common parental melt.

Geochemical implications of partial meltingEdit

The degree of partial melting is critical for determining what type of magma is produced. The degree of partial melting required to form a melt can be estimated by considering the relative enrichment of incompatible elements versus compatible elements. Compatibility geochemistry elements commonly include potassium, barium, caesium, rubidium.

Rock types produced by small degrees of partial melting in the Earth's mantle are typically alkaline (Calcium, Sodium), potassic Potassium and/or peralkaline (high aluminium to silica ratio)). Typically, primitive melts of this composition form lamprophyre, lamproite, kimberlite and sometimes nepheline-bearing mafic rocks such as alkali basalts and essexite gabbros or even carbonatite.

Pegmatite may be produced by low degrees of partial melting of the crust. Some granite-composition magmas are eutectic (or cotectic) melts, and they may be produced by low to high degrees of partial melting of the crust, as well as by fractional crystallization. At high degrees of partial melting of the crust, granitoids such as tonalite, granodiorite and monzonite can be produced, but other mechanisms are typically important in producing them.

At high degrees of partial melting of the mantle, komatiite and picrite are produced.

Composition and melt structure and properties Edit

Silicate melts are composed mainly of silicon, oxygen, aluminum, alkalis sodium, potassium, calcium), magnesium and Iron. Silicon atoms are in tetrahedral coordination with oxygen, as in almost all silicate minerals, but in melts atomic order is preserved only over short distances. The physical behaviours of melts depend upon their atomic structures as well as upon temperature and pressure and composition (e.g., Watson and others, 2006)

Viscosity is a key melt property in understanding the behaviour of magmas. More silica-rich melts are typically more polymerized, with more linkage of silica tetrahedra, and so are more viscous. Dissolution of water drastically reduces melt viscosity. Higher-temperature melts are less viscous.

Generally speaking, more mafic magmas, such as those that form basalt, are hotter and less viscous than more silica-rich magmas, such as those that form rhyolite. Low viscosity leads to gentler, less explosive eruptions.

Main article: Igneous differentiation

Characteristics of several different magma types are as follows:

Ultramafic (picrite)
SiO2 < 45%
Fe-Mg >8% up to 32%MgO
Temperature: up to 1500°C
Viscosity: Very Low
Eruptive behavior: gentle
Distribution: divergent plate boundaries, hot spots, convergent plate boundaries; komatiite and other ultramafic lavas are mostly Archean and were formed from a higher geothermal gradient and are unknown in the present
Mafic (basaltic)
SiO2 < 50%
FeO and MgO typically < 10 wt%
Temperature: up to ~1300°C
Viscosity: Low
Eruptive behavior: gentle
Distribution: divergent plate boundaries, hot spots, convergent plate boundaries
Intermediate (andesite)
SiO2 ~ 60%
Fe-Mg: ~ 3%
Temperature: ~1000°C
Viscosity: Intermediate
Eruptive behavior: explosive
Distribution: convergent plate boundaries
Felsic (rhyolitic)
SiO2 >70%
Fe-Mg: ~ 2%
Temp: < 900°C
Viscosity: High
Eruptive behavior: explosive
Distribution: hot spots in continental crust (Yellowstone National Park), continental rifts, island arcs

ReferencesEdit

  • E. B. Watson, M. F. Hochella, and I. Parsons, editors, Glasses and Melts: Linking Geochemistry and Materials Science. Elements, v. 2, pages 259-297 (2006). http://www.elementsmagazine.org/

See alsoEdit



Smallwikipedialogo.png This page gets some of its content from Wikipedia. The source article was at Wikipedia:Magma. The list of authors can be seen in the page history. As with Geology Wiki, the text of Wikipedia is available under the GNU Free Documentation License.

Around Wikia's network

Random Wiki